Water Heater Henderson

• A heavy inner steel tank that holds the hot water. The tank holds 40 to 60 gallons, sometimes more. It has to be able to hold the pressure of a residential water system, which typically runs at 50 to 100 pounds per square inch (psi). The tank is tested to handle 300 psi. The steel tank normally has a bonded glass liner to keep rust out of the water.
• Insulation surrounding the tank
• A dip tube to let cold water into the tank
• A pipe to let hot water out of the tank
• A thermostat to control the temperature of the water inside the tank.
• Heating elements or a natural burner to heat the water.
• A drain valve that allows you to drain the tank to replace the elements or move the tank
• A pressure relief valve (This is an important safety feature that keeps the tank from exploding.)
• A sacrificial anode rod to help keep the steel tank from corroding
• An exhaust pipe to vent the natural or lp gas heater

The dip tube is another name for the cold water inlet. If you are facing the front of the water heater (where the labels are), the cold water inlet, or dip tube, is on the right hand side.

For most water heaters, the anode rod is attached to the hot water outlet of the water heater. If you are facing the front of the water heater (where the labels are), the hot water outlet is on the left hand side. The anode rod is often referred to as a “sacrificial rod”.

We don’t have to tell youthat las Vegas water is not “pure”. It can contain oxygen, magnesium, fluoride, chlorine and suspended particles. These components, in the concentrations in your water, are usually not bad for you. However, they do contribute to the taste and smell of the water. They also impart a slight conductivity to the water. Through an electrical process called electrolysis, this conductivity will eventually (over a long period of time) cause most metal to rust or corrode. When the water is heated, this electrical process can be accelerated.

Call Henderson Plumbing to replace you water heater today wit ha high quality unit at a guaranteed low price..

Kitec pipe and fittings fail when they are exposed to water because of a chemical reaction known as dezincification, which results in reduced water flow and leaks. Dezincified Kitec pipe and fittings cause damage not only when they burst and leak, but also impair the ability of a home’s plumbing system to effectively provide water to appliances and fixtures.

A residential plumbing system preferred by plumbers and contractors because it is less expensive, and easier to work with than copper, has a damning Achilles’ heel that can be likened to a ticking time bomb: Kitec brass fittings that can fail and leak, putting a home’s structure and contents at risk.

The actual pipe itself, which is known as pex pipe, isn’t the problem. In fact, according to a number of plumbers and contractors contributing to a contractor’s blog, the pipe product itself is pretty good stuff. Rather than a single layer of pex tubing, the Kitec XPA pipe is in actual fact two layers of pex pipe, with a layer of flexible aluminum sandwiched in between. This feature not only affords the pipe added strength, but plumbers report it is easier to work with, in that it will not readily uncoil like standard pex pipe. As well, once the plumber bends the pipe into shape, it will retain that shape.

PlumberHere’s the problem: the brass fittings, which have been reported to fail over time, appear to have a higher concentration of lead in the brass formulation. This, in turn can lead to dezincification, a powdery white corrosion that can build up in the fitting, restricting the water flow and contributing to a failure—either at the fitting connection itself, or at some other point in the line impacted by the restricted flow, increased pressure, or both. -

Kitec Failed Fittings: Like a Ticking time Bomb

February 10, 2008. By Gordon Gibb

Plan Ahead for Those Henderson Plumbing Emergencies

Find your Henderson plumber now, before you have an emergency. You can’t think clearly when your bathroom is flooded with raw sewage or the washer has overflowed in the upstairs laundry room. Program our phone number, 702-989-3202, into your cell phone now to be ready for plumbing emergencies and you’ll always have a Henderson NV plumber available when you need one.

Henderson Plumber Services: Serving Henderson and Las Vegas

Henderson NV Water Heaters

Nevada

If you live in Henderson Nevada, you will need a plumber at some point for additions on to your home or office or to replace the water heater. Most of us don’t know any Henderson plumbers. That’s o.k. because your plumbing is so reliable and requires so little maintenance, we tend to take plumbing for granted. We turn on the faucet, flush the toilet and run the washer and dishwasher without a thought. Without a thought, that is, until something goes wrong. Then panic sets in and you find yourself scrambling to locate a plumber in the Henderson – Las Vegas – Boulder City area.

Henderson Plumber Complete Plumbing Service

Of course if you don’t have an emergency plumber Henderson situation but you’re planning a bathroom or kitchen remodel we hope you’ll call Henderson plumber early in the project planing stage. We can show you how to minimize the relocation of pipes and help you pick out plumbing fixtures, like sinks and toilets, that won’t bust your budget.

This can be a good time to ask those all important questions about pricing, average time to respond to a call and if they provide 24/7 emergency service. Finding a Henderson NV plumber that will install your new fixtures and appliances and is also available should you have an emergency is important.

Henderson Plumber is Licensed and Insured

When searching for a Henderson plumber you can ask for recommendations from family and friends but always insist on a licensed Henderson plumbing expert. They may tell you they have a friend or relative that does plumbing in Henderson and can probably help you out and you might be tempted because the price is low. But are they a licensed Henderson plumber? Probably not and you might end up with more problems than you started with. It’s important that any recommendations you get are for a licensed and insured Henderson plumbers as they will always stand behind their work and if anything should go wrong, you know you’re covered.